xxx

 
ADEKA MC-2010MN and P-201 INSTALLATION:-

 



MC-2010MN comes packaged in 25 metre rolls and can be easily applied in construction / cold joints as shown here and in the following photos.
Check MC-2010MN data sheet for minimum requirements. (Concrete coverage, wall/slab thickness and wall height)

Placing initial strip of MC-2010MN in the centre of the footing. Caution must be taken here to avoid leaving the MC-2010MN too close to the interior or exterior of the substrate. This scenario could cause the MC-2010MN to blow the concrete out due to swelling pressure if it comes in contact with water.

 










To join two strips of MC-2010MN at a corner, butt them as shown here and place a bead of P-201 at the joint to ensure a tight seal.

 





The connection should appear something like this after application of P-201.
 





The best method of joining two strips of MC-2010MN is to overlap as shown here, using a small bead of P-201 in the area of overlap.
 









P-201 can be used in combination with MC-2010MN to seal around unusually shaped areas such as the one shown here.
The yellow stain surrounding the concrete is a contact adhesive(Bostik 1222) which adheres the Adeka MC-2010MN onto all porous substrates.
Waterproofing Warehouse keeps Bostik 1222 in stock in 4 Litre packaging.

 






Place a small bead of P-201 under MC-2010MN when the concrete surface is particularly rough or uneven.
 






Transition from smooth to rough concrete can be accommodated by using MC-2010MN and P-201 in combination as shown here.
xxxThe logo's below are links to product pages for these companies: -
xxxx

HOME